Roller hemming systems for doors & lids

Our hemming tools have been developed to meet the quality and planning requirements of modern door and lid systems.

Combined with corresponding production fixtures, there are different possibilities in the installation of the system as well as realization of different cycle times. Our hemming systems guarantee an even hemming result with optimum adhesive distribution within the hemming geometry.

The tools are protected against overload. Optionally, they are attachable to a force control device to facilitate commissioning or as a process control system in mass production.

The use of high quality and high strength materials lead to an outstanding lifetime with a minimum of maintenance required.

Technical data FW100 – hemming tool for closure panels
Weight max. 12 kg (approx. 10 kg without force control device)
Pre-load 1.000 N by elastomer suspension
> 1.000 N on request
Process forces < 1.000 N rigid system
1.000 - 2.000 N spring-loaded system
> 2.000 N on request
Features o less wear out
o protection against overload
o compact and modular set-up
o easy to use

FW_100_00_VAR_01

Hemming tool without force control device with

  • 2 × standard roller
  • 1 × pin for calibration short

FW_100_00_VAR_02

Hemming tool without force control device with

  • 1 x standard roller
  • 1 x standard shaft
  • 1 x pin for calibration short

FW_100_00_VAR_03

Hemming tool without force control device with:

  • 2 x standard roller
  • 1 x standard shaft
  • 1 x pin for calibration long

 

 

FW_100_00_VAR_04

Hemming tool without force control device with:

  •  2 x standard roller or shaft
    (to be used for e.g. glass channel area at doors)

FW_100_00_VAR_11

Hemming tool with force control device and:

  • 2 x standard roller
  • 1 x pin for calibration short

FW_100_00_VAR_12

Hemming tool with force control device and:

  • 1 x standard roller
  • 1 x standard shaft
  • 1 x pin for calibration short

FW_100_00_VAR_13

Hemming tool with force control device and:

  • 2 x standard roller
  • 1 x standard shaft
  • 1 x pin for calibration long

FW_100_00_VAR_14

Hemming tool with force control device and:

  • 2 x standard roller or shaft
    (to be used for e.g. glass channel area at doors)
Kontakt

ContaCtformular EngRoTec Solution

ContaCtformular
captcha

Headquarters

EngRoTec - Solution GmbH
Zum Wolfsgraben 5
36088 Hünfeld

T +49 665 279 394 84 80

solutions@engrotec.de

Please read our privacy policy before you use this contact formular.

Privacy Policy